PSPRS -

ActiveX Control Installation
1. If you have not done "IE Security Settings" and "Machine Rights", please do so now before proceeding.
2. Print this page.
After printing CLICK HERE to proceed with the installation and follow steps 3 - 11.
3. For the following message box, click "OK".
	(Note: If this message box does not appear, please proceed to number 4)

4. Click the bar that says "click here..." and select "Always Allow Pop-ups From This Site..."
	(Note: If this window does not appear, please proceed to number 5)

5. Click the bar that says "Click here to install…" and select "Install ActiveX Control".
	(Note: If this window does not appear, please proceed to number 6)

6. Click "Install".
	Note: As stated before, you must have administrator rights. If the installation fails, please consult your Network Administrator. If you do not have a network administrator, please refer to "Machine Rights" documentation explaining how to tell if you have administrator rights.

At this point, you have successfully installed the 1st ActiveX Control! Though the screens will look the same, please proceed with steps 7 - 11 to install the 2nd ActiveX Control.
7. Click "OK".
	(Note: If this message box does not appear, please proceed to number 8)

8. Click the bar that says "Click here to install…" and select "Install ActiveX Control".
	(Note: If this window does not appear, please proceed to number 9)

9. Click "Install".

10. Click "Yes".
	(Note: If this message box does not appear, please proceed to number 11)

11. The Member's Only application is now ready to use.
	If known, enter "Login Name" and "PIN", otherwise click "Setup Login".